Hampden single-sunk 18s (45.8mm). Dial feet at 14.0, 36.4, 51.9.

No hairlines. Really nice anchor logo dial.

Hampden single-sunk 18s (45.8mm). Dial feet at 14.0, 36.4, 51.9.

One hairline and a couple of edge chips but will still face up nicely.

Hampden single-sunk 18s (45.8mm). Dial feet at 14.0, 36.4, 51.9.

No hairlines.

Hampden single-sunk 18s (45.8mm). Dial feet at 21.5, 37.0, 59.0.

Several light hairlines.

Hampden single-sunk 18s (45.8mm). Dial feet at 14.0, 36.4, 51.9.

No hairlines but a chip extending into the chapter ring at the 48 minute mark.

16 size, double-sunk, 'Special Railway' dial. According to James Hernick's book, this would have been found on the No. 104 Model 1 & 2. Has edge chipping that takes out part of some of the red numbers. Two hairlines on either side of the 'I'.

16 size, double-sunk, dial. Dial feet at 24.4, 37.2, 58.0.

One hairline just below the '10'.

Edge hairlines between the '11' and '12'.

Hampden single-sunk 6s (33.4mm). Dial feet at 12.7, 37.0, 50.2.

No hairlines, small edge chip outside the 10 minute mark.

Hampden single-sunk 6s (34.4mm). Dial feet at 12.7, 37.0, 50.2.

No hairlines, a couple of very small edge chips.

Hampden single-sunk 6s (34.4mm). Dial feet at 12.7, 37.0, 50.2.

No hairlines, a few edge chips .

Hampden 3/0s (26.6mm). Dial feet at 13.0, 38.8, 54.2.

No hairlines or chips.

Hampden 3/0s (26.6mm). Dial feet at 13.0, 38.8, 54.2.

An edge hairline going from the 35 minute mark to the 42 minute mark and a chip outside the 35 minute mark.

Hampden 3/0s (26.6mm). Dial feet at 13.0, 38.8, 54.2.

Light hairline going from the seconds bit out through the '9'.

Hampden 3/0s (26.6mm). Dial feet at 13.0, 38.8, 54.2.

Small rust stain and tiny chip on the seconds bit.